MAMEWorld Central >> Hardware
Previous thread Previous  View all threads Index   Next thread Next   Flat Mode Flat  

italieAdministrator
MAME owes italie many thank yous, hah
Reged: 09/20/03
Posts: 15226
Loc: BoomTown
Send PM
Re: Wells Gardner Color Issue
05/11/13 05:39 AM


> Hi Everyone --
>
> Having an issue where the color being displayed on my Wells Gardner D9200 Monitor
> appears to be muted (specifically the color blue seems to be low).
>
> I tried to adjust the settings through the normal and secret Wells Gardner menu
> (using recommended settings for this monitor) with no success in correcting the
> issue.
>
> The odd issue is that the WG menu pop-up and no signal screens are in bright bold
> colors, but the actual signal from the computer is not.
>
> ArcadeVGA3000, Windows XP SP3
>
> Any suggestions?
>
> Also, if there is a MAME expert in the Los Angeles area would really appreciated some
> in person help!
>
> Thank you.


A couple of thoughts, best I can recall:

- Check cables as others have instructed.

- There is a satellite board off to side of the chassis. Resistors and diodes tend to burn up on it. Check them for proper ohm, and any signs of heating, or just replace.

- The neck-board drivers tend to flake on those as well. Check them out of circuit, or just replace.







Entire thread
Subject Posted by Posted on
* Wells Gardner Color Issue Mame818 05/10/13 10:17 PM
. * Re: Wells Gardner Color Issue italieAdministrator  05/11/13 05:39 AM
. * Re: Wells Gardner Color Issue Bad A Billy  05/11/13 03:20 AM
. * Re: Wells Gardner Color Issue Sune  05/10/13 11:05 PM

Extra information Permissions
Moderator:  Gatinho 
0 registered and 7 anonymous users are browsing this forum.
You cannot start new topics
You cannot reply to topics
HTML is enabled
UBBCode is enabled
Thread views: 2208