|
|
Re: Inherited, Previously Working MAME Cabinet. Restoring issues.
09/23/15 06:23 AM
|
|
|
That goes to the pcb on the monitor. There should be a row of connectors & it should only connect to them in 1 way so no problems there but, I'm not sure where it's coming from. It appears to be coming from the jamma board? Does the pc have an arcadevga or does that jamma board convert the signal properly for the crt? If you don't know but that was how it was hooked up before then you should be OK. If not sure, you could do damage to any/all of the parts involved there so don't do it until you're certain!
I'm not familiar with that type of jamma board so I'm guessing. It's a little hard to tell what's going where & from where.
I'll assume that the video signal is coming from PC to the jamma board & then out to the zenith crt. Also that the jamma harness is coming from the controls to the board & then back in to the PC via PS/2? What are the other ports on the jamma board? Can you post some more pix of things?
Maybe this will help get you going in the right direction and some others can chime in with their thoughts.
GL
Pessimist: Oh, this can't get any worse!
Optimist: Yes, it can!
|
|
Index 
Flat 
Re: Inherited, Previously Working MAME Cabinet. Restoring issues.
Reply
Inherited, Previously Working MAME Cabinet. Restoring issues.
