Frontend Tech + >> Ultimarc
Previous thread Previous  View all threads Index   Next thread Next   Flat Mode Flat  

sparten11
MAME Fan
Reged: 10/07/16
Posts: 1
Send PM
I need help
10/07/16 09:02 PM


i have the new ipac 2 just purchased last week. i can get it working great and driving my mach 3 cnc interface but the board keep locking up and stops working no keypress can be seen. nothing happens. it locks up. i pull the usb out wait short while and plug back in, and viola it works once again for a short while then it quits again. anyone else having this issue with locking up and having to unplug and re plug the board in?






Entire thread
Subject Posted by Posted on
* I need help sparten11 10/07/16 09:02 PM
. * Re: I need help Traso  10/09/16 02:48 AM

Extra information Permissions
Moderator:  Andy Warne 
0 registered and 1 anonymous users are browsing this forum.
You cannot start new topics
You cannot reply to topics
HTML is enabled
UBBCode is enabled
Thread views: 632