MAMEWorld >> Hardware
View all threads Index   Flat Mode Flat  

italieAdministrator
MAME owes italie many thank yous, hah
Reged: 09/20/03
Posts: 15229
Loc: BoomTown
Send PM
Re: NOOB Needs a little advice/support
03/14/11 03:24 AM


> OK,,update,,I went today to see if I could investigate the coin operation, but when I
> turned on, I noticed a loud hissing from the anode. I discharged the monitor, removed
> the cap and noticed the cup was damaged. I replaced with one from an old monitor I
> had, booted up and this is the screen that keeps coming up now. NOTE: this is the
> screen that come up before I discharged and replaced the cap. Could this be a board
> issue rather than a monitor issue?

I would say board issue, either a bad/mis-seated RAM, a bad/mis-seated EEPROM, or your voltages are a little low. Could be other thins to, but those are the usual culprits to check first.

If those boards have ribbon cables, make sure they are secure as well.







Entire thread
Subject Posted by Posted on
* NOOB Needs a little advice/support weedsmacker 03/06/11 11:47 PM
. * Re: NOOB Needs a little advice/support italieAdministrator  03/07/11 12:24 AM
. * Re: NOOB Needs a little advice/support weedsmacker  03/09/11 01:39 AM
. * Re: NOOB Needs a little advice/support weedsmacker  03/10/11 01:51 AM
. * Re: NOOB Needs a little advice/support italieAdministrator  03/10/11 03:25 AM
. * Re: NOOB Needs a little advice/support weedsmacker  03/11/11 01:42 AM
. * Re: NOOB Needs a little advice/support weedsmacker  03/11/11 01:52 AM
. * Re: NOOB Needs a little advice/support italieAdministrator  03/11/11 03:18 AM
. * Re: NOOB Needs a little advice/support weedsmacker  03/12/11 04:25 AM
. * Re: NOOB Needs a little advice/support weedsmacker  03/13/11 08:38 PM
. * Re: NOOB Needs a little advice/support italieAdministrator  03/14/11 03:24 AM
. * Re: NOOB Needs a little advice/support weedsmacker  03/15/11 01:23 AM
. * Re: NOOB Needs a little advice/support italieAdministrator  03/15/11 01:44 AM
. * Re: NOOB Needs a little advice/support weedsmacker  03/16/11 12:09 AM
. * Re: NOOB Needs a little advice/support weedsmacker  03/17/11 01:07 AM

Extra information Permissions
Moderator:  GatKong 
0 registered and 4 anonymous users are browsing this forum.
You cannot start new topics
You cannot reply to topics
HTML is enabled
UBBCode is enabled
Thread views: 3194