Thanks, Tried another monitor I had from an off road thunder and it comes up with an out of range. I am assume this to be once again since it is a 31Khz and looking for a higher scan rate than the exotica puts out.
Any idea on what the seattle atari hardware is. I have a couple california speeds that I could test this board in as well. Just don;t want to go through the work if once again it is most likely not going to work.
What is weird is I am using a WG D9500 that should sync 15~41Khz, but it reports out of range.
got the board running on a D9200 with no problem, once i moved a connector from VGA to CGA on the ribbon. Thanks again.
Edited by jmurjr (06/29/11 12:31 AM)