MAMEWorld >> Hardware
View all threads Index   Flat Mode Flat  

Reged: 12/06/12
Posts: 2
Send PM
Konami Racing Jam help needed
12/31/12 04:10 PM

I working on a hacked board from a friend's Racing Jam and I'm hoping someone here can help me with some photos. The board is labeled KONAMI GN676 PWB (A)B
I'm just hoping someone here has a similar board and can help me.

Someone who should never be allowed to even touch a soldering iron trashed the area around the M48T58-Y timekeeper chip, both top side and bottom. I think the timekeeper is labeled "35D" but can't tell for sure thanks to the "repair". I'm trying to rebuild all the destroyed traces but I can't tell where some of them go or come from on the board I have.

I would REALLY appreciate a high-res focused photo of the underside of the board around the 28-pin socket. I was able to rebuild most of these traces but there are a couple I'm not sure of and I do not have a schematic to look at.

I also need a photo of the top side of the board in the area just above the 28-pin socket. If you could remove the chip first that would be a plus. Just above the top side of the socket are some traces and vias that are mostly missing from this "repair" and I need to see what used to be there so I can rebuild it.

Finally, just to the right of the time keeper, and to the left of LS245 and LS273, I have a 100K 1/2 Watt resistor on my board but it is obviously NOT factory installed. If someone can verify what this component is and if it is indeed a 100K Ohm resistor, that would be a plus.

Many thanks in advance for any photos or drawings. I'll gladly return the favor if anyone needs any help with early Bally solid state pinball machines.


Entire thread
Subject Posted by Posted on
* Konami Racing Jam help needed NolensvilleSteve 12/31/12 04:10 PM

Extra information Permissions
Moderator:  GatKong 
0 registered and 3 anonymous users are browsing this forum.
You cannot start new topics
You cannot reply to topics
HTML is enabled
UBBCode is enabled
Thread views: 1882