MAMEWorld >> Hardware
Previous thread Previous  View all threads Index   Next thread Next   Flat Mode Flat  

Bad A Billy
Oop Ack!
Reged: 12/27/07
Posts: 1007
Loc: Outland
Send PM
Easy monitor question...
05/04/13 05:18 AM

Any suggestions would be welcomed. Monitor diagnosis & repair is beyond my limited knowledge.

Story: Took chips out a game (small bartop cab) to dump. Stored in garage until this week when I put the chips back in. Fired it up and nothing. Re-seated chips still nothing. PCB leds on. Checked wiring and voltages - all OK. Open the back up and there is just a small whisp of smoke(REAL small)... Finally track it down to the seal between where the guns go into the back of the tube(?)

I imagine it's dead...Is it repairable??
Also, shouldn't the game still boot(w/sounds) even with a bad crt?

I also have an old Pole Position monitor that works(?) Turns on and off but to a white screen, it can be turned down to dark. Haven't got the board working yet so I haven't tried another board with it yet. Any ideas on this one?

Thanks for the help guys...

Pessimist: Oh, this can't get any worse!
Optimist: Yes, it can!

Entire thread
Subject Posted by Posted on
* Easy monitor question... Bad A Billy 05/04/13 05:18 AM
. * Re: Easy monitor question... italieAdministrator  05/04/13 08:51 AM
. * Re: Easy monitor question... Bad A Billy  05/04/13 11:56 PM
. * whhhhhOOPPP....whhhooooOOOOOP....... Danger Will Robinson.... italieAdministrator  05/05/13 12:29 AM
. * Re: whhhhhOOPPP....whhhooooOOOOOP....... Danger Will Robinson.... Bad A Billy  05/05/13 04:47 AM

Extra information Permissions
Moderator:  GatKong 
0 registered and 1 anonymous users are browsing this forum.
You cannot start new topics
You cannot reply to topics
HTML is enabled
UBBCode is enabled
Thread views: 2170