MAMEWorld >> Hardware
View all threads Index   Flat Mode Flat  

Reged: 01/23/06
Posts: 287
Send PM
Re: Existing Wiring question
05/28/15 08:51 PM

The EASIEST way would be to use a J-PAC rather than an I-PAC.

If you want to stay with the I-PAC, yes you will have to cut into the existing wiring. Rather than cutting all wires and then tracing them back to the buttons, google the JAMMA connection standard and then cut the wires one at a time from the relevant pin on the JAMMA connector and connect it to the I-PAC before moving on to the next one.

Use a power strip for the computer.
Whether to connect the marquee light to the PSU or power strip would depend on what input voltage the light would require and whether the PSU could support all demands.

Entire thread
Subject Posted by Posted on
* Existing Wiring question zenbone 05/28/15 08:04 PM
. * Re: Existing Wiring question bodger319  05/28/15 08:51 PM
. * Re: Existing Wiring question zenbone  05/28/15 09:08 PM

Extra information Permissions
Moderator:  GatKong 
0 registered and 1 anonymous users are browsing this forum.
You cannot start new topics
You cannot reply to topics
HTML is enabled
UBBCode is enabled
Thread views: 1958