MAMEWorld >> Hardware
View all threads Index   Flat Mode Flat  

Reged: 08/15/16
Posts: 2
Send PM
new cabinet maker here.
09/22/16 04:19 PM

hi, i have an old cabinet i've gutted. i'm going to run an emulator using a windows 7 machine. i'm kind of learning this as I go, and so far so good. I have my joystick and buttons working via a usb controller. I just have a couple of questions for anyone out there who's gone through this process before.

1. what should I look for in a monitor? more than just what will fit in my cabinet? I still have the bezel that went around the crt if that's at all useful. not sure at this point.

2. Is there a standard button layout I should use? I'm making a new panel for the joystick and buttons. I have 13 buttons I can use.

Thanks for any advice.


Entire thread
Subject Posted by Posted on
* new cabinet maker here. soldsoul4foos 09/22/16 04:19 PM
. * Re: new cabinet maker here. soldsoul4foos  09/24/16 07:58 PM

Extra information Permissions
Moderator:  GatKong 
0 registered and 2 anonymous users are browsing this forum.
You cannot start new topics
You cannot reply to topics
HTML is enabled
UBBCode is enabled
Thread views: 1368