MAMEWorld Forums - Hardware - Discs of tron joystick shield button

Hello
I am building a control panel for discs of tron game with a ultimate Ipac control board I bought a LED fire button link below

https://www.newark.com/multicomp/r13-548...R13-548AL-05-BR - Illuminated Pushbutton Switch, R13-584 Series, SPST, Off-(On), 3 A, 250 V

and I am trying to figure out how to connect it to the control board.
It has 3 legs on it a power leg, switch ground leg, and a LED ground leg it also has a resistor built in to the LED.
My main question is would I be able to tie this with the ultimate ipac connection 2B the led would be on when not in use and blink off when the shield button is pressed I am not sure if this would be too much of a draw on the board.
Or do you know of a better button to use on the joystick with separate wires for the led and the switch.
Any help would be appreciated.

[ATTACHED IMAGE - CLICK FOR FULL SIZE]

Edited by Bosco (11/28/18 04:34 AM)