MAMEWorld Forums - Hardware - Analog controls with an arcade controller board?

I've seen a couple DIY/homemade controllers that have dual analog sticks that usually require an amount of programming/coding. But none with analog trigger controls.

I'm assuming such a set-up would mean there'd be 6 analog inputs.

Up and Down, Left and Right for the Left Stick (2)

Up and Down, Left and Right for the Right Stick (2)

Then a Left trigger (1)

And a Right trigger (1)

Are there any controller boards that would have connection terminals for such inputs?

Or would my best bet be to get something like an Arduino and... go from there?

-----------

What I'm wanting to make is something with a central board to have switches for the digital inputs/buttons to be wired to said board.

I'd essentially be replacing anything that has a rubber contact switch with a microswitch similar to an arcade controller. But I'd also want any of the analog controls to remain intact. Using parts like these...

https://www.amazon.com/dp/B01MY3PT76

or https://www.amazon.com/dp/B07R7736QH

and this for the triggers

https://www.amazon.com/Replacement-Trimm.../dp/B093LFL7R9/

To somehow be wired up to the board.

Or is that even possible?

LEVEL-4

Edited by Tomu Breidah (10/12/21 11:51 AM)