Hello everyone,
I’m new to this forum and very eager to get my MAME machine going!
I purchased the J-Pac and ArcadeVGA (PCI-E) cards from www.ultimarc.com but I’m not able to get a proper picture on my arcade monitor (which is a Philips A48ABK05X).
My base cabinet for this project is the Blood Bros. game – info about it can be found here: http://www.arcade-history.com/?n=blood-bros.&page=detail&id=291
How do I determine the refresh rate of this monitor?
When I first plugged my arcade monitor into the VGA port on the card (at the same time as my PC monitor was plugged into the DVI port), I did not get a picture on the arcade monitor at all. However, after installing the ArcadeVGA driver, I got a rolling picture on the arcade monitor but at the same time my PC monitor lost its picture. Is this how it should work?
Also, the SYNC OK LED on the J-pac card is off.
Any help would be greatly appreciated!
Edited by Suave Kajko (08/27/11 07:54 PM)
|
Index 
Flat 
Can't get proper picture from ArcadeVGA card
Reply
