> If the board plays and you're getting inconsistent reads I can say with 99% certainty
> that you are using a Willem. They don't support 2716, 2732 or 2764 worth a crap. You
> might get lucky and get a few good reads but the support for them is terrible. There
> are probably a few different revisions of the hack so ideally it needs to be dumped
> but if you are using a Willem you probably won't get a good read. Even when it reads
> consistent crcs on those types of chips, one or two are probably bad.
Well, I guess I'm in the 1% then  It's an old Modular Circuit Technology model "MOD-MEP-1A" I'm borrowing from a friend. It's old enough that it requires a PC with an ISA slot! It seems to read 2716's just fine (almost always get the same CRC if I read one multiple times), but 2732's is where I get lots of multiple CRC's reading one chip. I can program 2732's with it, but it seems to have trouble with 2716's (unless the 3 I have are bad. They seemed to blank ok with a UV eraser).
|
Index 
Flat 
Re: Guru update - Falcon Kong Jr.
Reply
It's an old Modular Circuit Technology model "MOD-MEP-1A" I'm borrowing from a friend. It's old enough that it requires a PC with an ISA slot! It seems to read 2716's just fine (almost always get the same CRC if I read one multiple times), but 2732's is where I get lots of multiple CRC's reading one chip. I can program 2732's with it, but it seems to have trouble with 2716's (unless the 3 I have are bad. They seemed to blank ok with a UV eraser).
Re: Guru update - Falcon Kong Jr.
