> Hi All,
>
> I've been trying to get HLSL setup and have done a lot of reading to try and figure
> it all out myself. I'm happy to say I have it working to the point where I can run
> one rom.
>
> Whatever that first rom is, works great and I can visually tell that HLSL is enabled
> and I like the way it looks. The problem is, if I exit that rom and load another one
> (or even the same one that was just working 5 seconds before) i get an error about
> not being able to initialize the direct 3D device.
>
> Mame then crashes and if I start it up again, I can once again pick one rom and it
> works, but then, same as before, quit and start another game and it ends with a
> crash.
>
> I tried multiple hlsl settings and even just a stock mame.ini with hlsl on with no
> other settings changed causes this same issue.
>
> Anyone have a clue? I'm kind of at a loss. I'd understand if it didn't work, but I
> can see visually its working, but only for the first rom I select after running mame.
>
> Appreciate any ideas anyone has.
You are probably using an older version since you don't mention what version it is you are using? Please try 0.144 and report back after testing:
http://mamedev.org/release.html
Also, it's best to clear anything .INI out of HLSL folder leaving only the core .FX files as there are a number of commands which are not supported in the most current HLSL implementation.
|
Index 
Flat 
Re: HLSL works for first rom only....
Reply
